92402-1Y100 Tail Light for KIA Picanto 2011 Right

92402-1Y100 Tail Light Overview

Intended for replacement and wholesale supply, the lamp should be matched to the removed part before paintwork or final body assembly is completed.

The listed application is KIA Picanto 2011, with the lamp positioned on the right side. Use the photographs and specification table together when comparing the removed assembly.

Vehicle Fitment and Lamp Selection

Compare the lens contour, inner edge, locating tabs and rear casing depth with the original lamp. Similar-looking versions may use different brackets or body openings.

Confirm the production period and lighting package as well as the vehicle model. Facelift changes, regional equipment and body variants can alter the lens, reflector or fixing arrangement.

Housing, Lens and Electrical Interface

Match the electrical socket and locking tab before installation. Confirm separately whether the original vehicle uses replaceable bulbs, an LED board or an external control unit.

Inspect the lens for transport damage before fitting. The rear casing, vents and sealing edges should remain clean so moisture control and body fit are not compromised.

Installation Guidance

Support the assembly during fitting and engage each guide pin squarely. After fastening, verify panel alignment, sealing contact and all lighting functions.

After installation, test the parking light, brake light, turn signal, reversing light and fog-light function where applicable. Verify that no warning message remains on the instrument panel.

Automotive Lighting Product Specifications

Product type: Tail Light

Primary OE reference: 92402-1Y100

Cross-reference numbers: 92402-1Y100

Internal item code: KA04003-098

Vehicle brand: KIA

Vehicle model: Picanto

Model year: 2011

Installation position: Rear body / tail lamp opening

Side / orientation: Right

Selection basis: OE reference, vehicle application and physical comparison

Wholesale Supply and Packing

Trade orders can be prepared by side and vehicle application. Sharing clear images of the removed lamp helps confirm connector and mounting differences before packing.

The lens face, connector area and projecting brackets should be isolated inside the carton. Separate labels for left- and right-hand units help prevent picking errors in mixed shipments.

Frequently Asked Questions

Are bulbs or electronic modules included?

The supply scope follows the product photographs. Ask separately about bulbs, holders, LED drivers, wiring and control modules if they are not clearly shown.

Can a similar-looking lamp be used instead?

Appearance alone is not sufficient. The body opening, housing depth, mounting points, connector and lighting technology must all match.

What should be checked before installation?

Compare the removed lamp with the supplied images, inspect the seal and brackets, confirm the electrical plug and carry out a dry fit before final tightening.

What details are required for a trade quotation?

Provide the vehicle application, production year, installation side, quantity, destination and clear photographs of the original lamp.

Request a Product-Specific Quote

Contact AutoParts with the vehicle details, required side, quantity and destination. The photographed configuration can be reviewed before a wholesale quotation is prepared.

Housing check: Review both the visible lens shape and the concealed support points. The correct unit should sit evenly without forcing the body panel or nearby trim.

Electrical interface: Inspect the plug shape, terminal count and connector locking direction. Bulb holders, LED drivers, wiring looms and control modules are included only when visible in the supplied photographs.

Installation guidance: Clean the mounting area, inspect the body-side clips and place the lamp without force. Complete an illumination test before reinstalling interior trim or bumper components.

Wholesale enquiry: For an accurate quotation, provide the vehicle application, mounting side, required quantity and delivery country. Note whether bulbs or electronic modules are required.