92401-H9100 Tail Light for KIA Rio 2017 Left

92401-H9100 Tail Light Overview

This rear lamp assembly is intended for the listed vehicle application and provides a practical replacement route when the original unit is damaged, faded or no longer serviceable.

The listed application is KIA Rio 2017, with the lamp positioned on the left side. Use the photographs and specification table together when comparing the removed assembly.

Vehicle Fitment and Lamp Selection

Check the rear housing profile and fastener positions before ordering. A correct exterior shape does not guarantee that the hidden mounting geometry is the same.

Confirm the production period and lighting package as well as the vehicle model. Facelift changes, regional equipment and body variants can alter the lens, reflector or fixing arrangement.

Housing, Lens and Electrical Interface

Compare the socket layout and cable exit direction with the removed lamp. Lighting technology can differ between trim levels even when the lens shape appears similar.

Inspect the lens for transport damage before fitting. The rear casing, vents and sealing edges should remain clean so moisture control and body fit are not compromised.

Installation Guidance

Carry out a trial installation before final assembly. Check bracket engagement, wiring clearance, water-sealing surfaces and lamp operation after connection.

After installation, test the parking light, brake light, turn signal, reversing light and fog-light function where applicable. Verify that no warning message remains on the instrument panel.

Automotive Lighting Product Specifications

Product type: Tail Light

Primary OE reference: 92401-H9100

Cross-reference numbers: 92401-H9100

Internal item code: KA04003-145

Vehicle brand: KIA

Vehicle model: Rio

Model year: 2017

Installation position: Rear body / tail lamp opening

Side / orientation: Left

Selection basis: OE reference, vehicle application and physical comparison

Wholesale Supply and Packing

For wholesale enquiries, state the vehicle, production year, installation side, quantity and destination. Photos of the original front and rear faces help distinguish close variants.

The lens face, connector area and projecting brackets should be isolated inside the carton. Separate labels for left- and right-hand units help prevent picking errors in mixed shipments.

Frequently Asked Questions

Are bulbs or electronic modules included?

The supply scope follows the product photographs. Ask separately about bulbs, holders, LED drivers, wiring and control modules if they are not clearly shown.

Can a similar-looking lamp be used instead?

Appearance alone is not sufficient. The body opening, housing depth, mounting points, connector and lighting technology must all match.

What should be checked before installation?

Compare the removed lamp with the supplied images, inspect the seal and brackets, confirm the electrical plug and carry out a dry fit before final tightening.

What details are required for a trade quotation?

Provide the vehicle application, production year, installation side, quantity, destination and clear photographs of the original lamp.

Request a Product-Specific Quote

Contact AutoParts with the vehicle details, required side, quantity and destination. The photographed configuration can be reviewed before a wholesale quotation is prepared.

Housing check: Use the product photographs to confirm the lamp outline, corner radius, mounting ears and the relationship between the lens and surrounding body trim.

Electrical interface: The connector interface must seat fully without bending terminals or modifying the harness. Verify any bulb carrier, resistor or electronic module shown on the original assembly.

Installation guidance: Remove debris from the body opening and inspect the seal before installation. Tighten the fixings evenly, then confirm that the lamp does not contact adjacent panels.

Wholesale enquiry: When requesting a quotation, include quantity, destination and the exact rear position. Mixed orders should list left and right lamps on separate lines.