3M51-44210-AB ST Rear Spoiler for 2005 Ford Focus

3M51-44210-AB ST Rear Spoiler Overview

Reference 3M51-44210-AB identifies the ST-profile spoiler associated with the 2005 Focus hatchback.

Body-Style and Spoiler Identification

The raised aero form, support feet and trailing edge distinguish this component from standard Focus caps. Compare the original ST mounting pattern and the centre lamp provision before drilling or refinishing.

Dry Fit and Installation Method

Mark the hatch centreline and confirm all supports sit flat without rocking. Use suitable seals at penetrations, route lamp wiring away from sharp sheet metal and allow painted surfaces to cure before final assembly.

Product-Specific Mounting Context

The ST aero form creates larger support reactions than a simple trim cap. All feet must contact evenly, and any missing reinforcement or gasket should be restored before the raised spoiler is tightened.

Post-Installation Checks

Confirm the spoiler sits symmetrically, follows the surrounding body gap and does not flex at individual mounting points. Inspect the boot or hatch interior for moisture after the first wash.

Finish Care

Inspect fixing seals during routine body service. Repair paint chips near mounting holes promptly so trapped moisture cannot reach exposed sheet metal.

Automotive Replacement Part Specifications

Product type: ST Rear Spoiler

Primary OE reference: 3M51-44210-AB

Internal item code: FD02046-004

Vehicle brand: FORD

Model: Focus ST

Vehicle year: 2005

Applicable vehicle: 2005 FORD Focus ST

Installation position: Upper rear hatch

Identification detail: ST-style raised spoiler with performance-profile shape and hatch attachment geometry

Cross-reference numbers: 3M51-44210-AB

Trade Packing and Supply

Support the spoiler along its full span, isolate painted faces with non-abrasive film and protect studs or lamp openings from impact. Label FD02046-004, 3M51-44210-AB, body style and finish externally.

Frequently Asked Questions

What does 3M51-44210-AB identify?

3M51-44210-AB identifies the listed st rear spoiler for 2005 FORD Focus ST.

Which fitment details should be checked for FD02046-004?

Compare ST-style raised spoiler with performance-profile shape and hatch attachment geometry, body style, mounting points, end contours and any lamp opening.

Should the spoiler be painted before trial fitting?

No. Dry-fit and verify alignment first, then remove it for surface preparation and refinishing.

What checks follow installation?

Check hatch travel, roof clearance, lamp operation, sealing and even contact at every support.

What information is required for wholesale supply?

Provide 3M51-44210-AB, SKU FD02046-004, body style, finish requirement, destination and quantity.

Fitment verification: Confirm 3M51-44210-AB, body style, spoiler span, mounting pattern, lamp provision and surface contour.

Installation guidance: Dry-fit before painting; centre the spoiler, seal fixing points and tighten evenly without distorting the panel.

Purchase reference: Quote SKU FD02046-004, OE number, body style, finish requirement, vehicle details and quantity.